Mold remediation referrals for Tampa & nearby townsCall: (813) 437-5101
(813) 437-5101

Mold in Walls & Drywall in Brandon, FL

moldremediationtampabay.net

With 1990s houses and plenty of apartments, Brandon's wall mold usually starts with a leak in a pipe, an AC line or the unit upstairs.

Drywall stained or musty in Brandon?
Call now to be connected with a local mold remediation company in Brandon.
(813) 437-5101

Brandon wall mold mostly comes from water hidden in the cavity: an aging supply line, a water heater, an AC drain, a roof leak or a neighbor's unit above. The work is to find and stop that water, remove the moldy drywall and insulation under containment, and dry the studs before patching. Call the number on this page to be connected with a local mold remediation company in Brandon.

Opened wall showing mold on the back of drywall and on studs, mold in walls & drywall in Brandon, FL

What happens when you call

You'll be routed to an independent mold remediation company that works across eastern Hillsborough County. It helps to have a few things ready: which wall or room, how large the stain or soft area is, whether you can smell it in other rooms, and what you think the water source is. Say whether you own or rent and whether the building has units above or beside yours.

On the visit, the company should take moisture readings around the area to map how far the water spread, then write a scope that covers containment with plastic sheeting, the drywall and insulation to be removed, cleaning and drying of the framing, and how dryness will be confirmed before the wall is closed. Rebuilding is sometimes in the same quote and sometimes not, so ask.

What drives the cost

HomeAdvisor reports a typical Tampa-area mold job at $1,248 to $2,550. Angi's figures for walls specifically run from $1,075 to $21,500, with drywall repair at $1,075 to $3,125. Those are reported ranges, not quotes. The biggest variables:

  • How long the leak ran before anyone found it
  • Whether growth reached the framing or stayed on the drywall
  • Access, such as a second-floor unit, a ceiling below, or cabinets to pull
  • Whether the plumber or roofer's repair is part of the scope
Call now to be connected with a local mold remediation company in Brandon.
(813) 437-5101
Technician cutting an inspection opening in drywall, mold in walls & drywall in Brandon, FL

Local conditions in Brandon

Brandon is a large unincorporated suburb east of Tampa, crossed by I-75, the Selmon Expressway and Brandon Boulevard. The median home was built in 1992, so many houses still have original water heaters, supply lines and window seals that are past their best years. About 37 percent of housing is multi-family and roughly 44 percent of occupied homes are rented. In a stacked building, a leak from the unit above often shows first as a stain at the top of a wall or a ceiling corner, while the growth runs down inside the cavity.

Renters whose landlord hasn't fixed a leak can contact Hillsborough County Code Enforcement, which enforces the county's property maintenance code. Structural repair permits come from Hillsborough County Development Services.

Before the company arrives

  • Turn off the water at the fixture or main if it is still leaking
  • Photograph the wall, ceiling and floor near the damage
  • Write down when you first noticed the stain or odor
  • Let your landlord or association know in writing
  • Leave the area as is rather than scrubbing it

Mold in Walls & Drywall questions in Brandon

I rent and there's mold coming through a wall. What should I do?
Tell your landlord in writing, with photos and dates, so the leak behind it gets repaired. If it isn't fixed, the local code enforcement office handles property maintenance complaints. In Brandon, that is Hillsborough County Code Enforcement.
How much drywall usually gets cut out?
Typically the stained or wet section plus a margin of sound drywall around it, so the edges of the growth aren't left behind. The final line is set on site using moisture readings, not just what shows on the paint.
Should the leak be fixed before the mold work starts?
Yes. EPA's guidance is that mold control is moisture control: if the water problem isn't fixed, the mold comes back. Stop the leak, then remove and dry.
Does the color of the mold on my drywall matter?
No. Color does not tell you how risky a mold is. Any mold growing in a wall gets the same treatment: find the water, remove what can't be cleaned and dry the structure.

More mold services in Brandon

Mold in Walls & Drywall nearby

Call now to be connected with a local mold remediation company in Brandon.
(813) 437-5101

Last updated:

☎ Call (813) 437-5101