Mold remediation referrals for Tampa & nearby townsCall: (813) 437-5101
(813) 437-5101

Mold in Walls & Drywall in Mulberry, FL

moldremediationtampabay.net

In Polk County's Bone Valley, wall mold comes from leaks, AC water and humidity rather than surge.

Mold on a wall in your Mulberry home?
Call now to be connected with a local mold remediation company in Mulberry.
(813) 437-5101

Mulberry is inland in Polk County, so mold inside its walls almost always starts with a household water problem: an AC drain, a plumbing leak, a roof leak or trapped humidity. Once growth is inside the cavity, the drywall and insulation must be removed and the framing dried before rebuilding. Call the number on this page to be connected with a local mold remediation company in Mulberry.

Opened wall showing mold on the back of drywall and on studs, mold in walls & drywall in Mulberry, FL

What usually puts water inside a Mulberry wall?

Mulberry is a small city in Polk County's Bone Valley, known for phosphate mining and about 30 miles from Tampa, with State Road 60 running through town. It's far from the Gulf, so the water feeding wall mold here usually comes from inside the house or from the roof. Central Florida's long, humid summers keep air conditioners running most of the year, and each one produces a steady stream of condensate. If the drain line clogs or the pan rusts through, that water lands on the nearest wall. Roof leaks after afternoon thunderstorms and slow drips from supply lines behind sinks, toilets and washers are the other common sources. Exterior walls can also collect condensation where humid air meets a cold surface.

Why does the mold keep coming back after I clean it?

Because the moisture is still there, or the growth is inside the drywall rather than on it. Wiping or spraying the paint surface can make a wall look clean for a few weeks, but if the back of the board and the insulation are wet, the stain returns. EPA says the key to mold control is moisture control and warns against painting or caulking over mold. The Florida Department of Health advises drying wet building materials within 24 hours, since common molds can take hold when water stands that long.

What does removal involve and cost?

A remediation company will contain the room, cut out the damaged section with a margin, bag the drywall and insulation, then clean and dry the framing until moisture readings are normal. Angi reports Tampa-area wall remediation at $1,075 to $21,500 and drywall repair at $1,075 to $3,125; those are regional ranges, and a Mulberry job depends on how much wall is involved, travel and drying time. Florida law keeps any testing with a separate mold assessor, not the remediator.

Call now to be connected with a local mold remediation company in Mulberry.
(813) 437-5101
Technician cutting an inspection opening in drywall, mold in walls & drywall in Mulberry, FL

A local note

Mulberry is an incorporated city, so ask the City of Mulberry about building permits before new drywall or framing goes in. For health questions about mold, the Florida Department of Health in Polk County's Environmental Health office in Bartow lists indoor air quality among its services. EPA advises that people with asthma or weakened immune systems stay away from moldy areas while work is underway.

Mold in Walls & Drywall questions in Mulberry

Can I cut out a small patch of moldy drywall myself?
EPA says a homeowner can usually handle an area smaller than about 10 square feet once the moisture problem is fixed. Wear gloves, goggles and an N-95 respirator, bag the debris, and stop and call a remediation company if the growth continues inside the cavity.
Can AC condensation cause mold inside a wall?
Yes. An air handler closet, a clogged condensate line or an overflowing drain pan can wet the drywall beside it for weeks. EPA advises keeping drip pans clean, drain lines flowing and indoor humidity below 60 percent.
Why does the mold on my wall keep coming back?
Because the water source is still active, or the wall was cleaned on the surface while growth stayed inside. Look for the leak, condensation or humidity problem feeding it and have the damaged drywall removed instead of wiped.
Can I stay in the house while walls are being opened?
Often yes, if the room is sealed with plastic and kept under negative air while drywall comes out. EPA says people with asthma or weakened immune systems should stay away from moldy areas, so ask how the containment is set up.

More mold services in Mulberry

Mold in Walls & Drywall nearby

Call now to be connected with a local mold remediation company in Mulberry.
(813) 437-5101

Last updated:

☎ Call (813) 437-5101